5K250 SATA OEM Specification
Page 30 of 171
6.3.6.4 Test considerations
Start/stop testing is classically performed to verify head/disk durability. The heads do not land on the disk,
so this type of test should be viewed as a test of the load/unload function.
Start/Stop testing should be done by commands through the interface, not
by power cycling the drive.
Simple power cycling of the drive invokes the emergency unload mechanism and subjects the HDD to
nontypical mechanical stress.
Power cycling testing may be required to test the boot-up function of the system. In this case HItachi
recommends that the power-off portion of the cycle contain the sequence specified in section 6.3.6.2,
"Required Power-Off Sequence”. If this is not done, the emergency unload function is invoked and
nontypical stress results.
To Next Page
Loading...
