Hitachi HUS VM - Page 370

raidcom delete journal
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E30 0062 The specified volume cannot be used as a journal
volume because it is an external volume that can
execute the I/O suppression mode.
Get Command
Status
Async 2E30 5002 The specified journal cannot be deleted because
there are data volumes.
CMDRJE Executing 2EE4 08E6 The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2EE4 50EE An internal error occurred.
Call Hitachi Data Systems customer support.
CMDRJE Executing B980 B903 The command was rejected because the selected
resource belongs to NAS_Platform_System_RSG.
Table 9-21 SSB codes returned by raidcom add journal
raidcom add journal
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 0000 The value of LDEV number is invalid.
CMDRJE Executing 2E00 0018 A new journal volume cannot be registered
because the number of journal volume exceeds the
maximum that can be registered.
Get Command
Status
Async 2E00 0023 The specified volume capacity is too small.
CMDRJE Executing 2E00 8301 The specified MP Blade ID is invalid.
CMDRJE
Get Command
Status
Executing/
Async
2E10 0000 The specified volume is already used by another
program product.
CMDRJE
Get Command
Status
Executing/
Async
2E10 0011 The specified volume is not installed or cannot be
used.
Get Command
Status
Async 2E10 001A The specified volume is connected from the
mainframe host.
CMDRJE
Get Command
Status
Executing/
Async
2E10 001B There is a PIN slot in the journal volume.
CMDRJE
Get Command
Status
Executing/
Async
2E10 001C The specified volume cannot be registered as a
journal volume because it is in shredding. Wait
until the shredding operation is completed, then
retry the operation.
9-46
Troubleshooting
Command Control Interface User and Reference Guide