Hitachi HUS VM - Page 369

raidcom add ldev
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
ERANGE Result too
large
Executing - - The value of the capacity is invalid.
Table 9-20 SSB codes returned by raidcom delete journal
raidcom delete journal
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 0000 The number of specified LDEV is invalid.
Get Command
Status
Async 2E00 0023 The specified volume capacity is too small.
CMDRJE Executing 2E00 5000 The specified journal ID is exceeds the range.
Get Command
Status
Async 2E10 0011 The specified volume is not installed or cannot be
used.
Get Command
Status
Async 2E10 0053 The specified volume is used in maintenance
operation.
Get Command
Status
Async 2E10 5000 The specified operation failed because the journal
or mirror is not in the operable status.
Get Command
Status
Async 2E10 5010 The journal volume cannot be deleted with the
specified journal status.
Get Command
Status
Async 2E11 800B The operation cannot be performed because it is in
the state of start-up.
Get Command
Status
Async 2E11 800E The operation cannot be performed because the
internal processing is in progress. Wait for a while,
then retry the operation.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
CMDRJE Executing 2E13 5002 The specified LDEV is not in the journal.
CMDRJE Executing 2E20 5000 The specified journal ID is not registered.
Get Command
Status
Async 2E21 5000 The operation failed because the specified journal
is not registered.
Get Command
Status
Async 2E21 8104 The journal volume cannot be added, or the
journal cannot be added to the extended
consistency group due to insufficient capacity of
the shared memory.
CMDRJE Executing 2E21 8105 The shared memory for Universal Replicator is not
installed.
CMDRJE Executing 2E23 0008 The number of specified LDEVs is invalid.
Troubleshooting
9-45
Command Control Interface User and Reference Guide