Hitachi HUS VM - Page 368

raidcom add ldev
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E30 0106 Volume whose emulation type is 3390-V cannot be
created in RAID1 parity group.
CMDRJE
Get Command
Status
Executing/
Async
2E30 4119 The virtual volume cannot be added because the
number of virtual volumes that can be created in
the system exceeded the maximum number.
CMDRJE
Get Command
Status
Executing/
Async
2E30 6003 The specified pool is the pool for Thin Image or
Copy-on-Write Snapshot.
Get Command
Status
Async 2E30 6012 The operation cannot be performed because the
specified pool is used for Data Direct Mapping.
Get Command
Status
Async 2E30 6014 The operation cannot be performed because the
specified pool is for active flash.
Get Command
Status
Async 2E31 6003 The operation cannot be performed with the
specified pool type.
CMDRJE Executing 2E31 6007 TSE-VOL cannot be created because of the
following conditions.
• The specified pool is other than HDPz pool.
• The specified emulation type is other than
3390-A.
CMDRJE Executing 2E31 6008 TSE-VOL cannot be created in combination with the
specified pool ID and the CU number of LDEV.
You must specify the even CU number for the pool
of even pool ID, and the odd CU number for the
pool of odd pool ID.
Get Command
Status
Async 2E31 6009 A TSE-VOL cannot be created in the specified pool
for Dynamic Tiering or active flash.
CMDRJE
Get Command
Status
Executing/
Async
2E3F 8000 The specified operation is not supported in the
current microcode version.
CMDRJE
Get Command
Status
Executing/
Async
2EBE 9E01 The specified parameter is invalid.
CMDRJE Executing 2EE8 00EE The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2EE8 FFFB An internal error occurred.
Call Hitachi Data Systems customer support.
CMDRJE Executing 2EF3 0002 The specified parameter is invalid. Check the
Command Control Interface Command Reference.
CMDRJE Executing B980 B903 The command was rejected because the selected
resource belongs to NAS_Platform_System_RSG.
9-44
Troubleshooting
Command Control Interface User and Reference Guide