raidcom initialize ldev
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E30 0074 The specified LDEV cannot be operated because it
is an external volume mapped for online data
migration.
CMDRJE Executing 2E30 0075 The specified ldev is used as the TSE-VOL.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0206 The operation cannot be performed because the
specified LDEV is a deduplication system data
volume.
CMDRJE Executing 2E30 0209 The operation cannot be performed because the
specified LDEV is a volume for which capacity
saving setting is enabled.
Get Command
Status
Async 2E31 0001 Maintenance work cannot be performed because
the target LDEV is a quorum disk.
Get Command
Status
Async 2E31 0017 LDEV cannot be formatted because there is no
normal external path.
CMDRJE Executing 2EE8 00EE The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2EE8 0A18 An internal error occurred.
CMDRJE
Get Command
Status
Executing/
Async
2EE8 FEEC An internal error occurred.
Call Hitachi Data Systems customer support.
CMDRJE
Get Command
Status
Executing/
Async
2EE8 FFFF An internal error occurred.
Call Hitachi Data Systems customer support.
CMDRJE Executing 2EF3 0002 The specified parameter is incorrect. Check the
Command Control Interface Command Reference.
CMDRJE Executing B980 B903 The command was rejected because the selected
resource belongs to NAS_Platform_System_RSG.
Table 9-30 SSB codes returned by raidcom modify ldev -command_device
raidcom modify ldev -command_device
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E10 0000 The command device cannot be set to the specified
LDEV because of the following causes.
• The LDEV is used for a ShadowImage pair.
• The reserve attribute of a ShadowImage is
configured.
CMDRJE Executing 2E10 0001 The specified LDEV is used for a TrueCopy pair.
9-56
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
