raidcom modify ldev -command_device
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E10 0002 The specified LDEV is used for a Universal
Replicator pair or a journal.
CMDRJE Executing 2E10 0004 The specified volume cannot be set because it is
used by a Thin Image pair or a Copy-on-Write
Snapshot pair.
CMDRJE Executing 2E10 0062 The specified LDEV is used as the primary volume
of a GAD pair.
CMDRJE Executing 2E10 0063 The specified LDEV is used as the secondary
volume of a GAD.
CMDRJE Executing 2E10 0201 The operation failed because the T10 PI attribute
of the specified LDEV is enabled.
CMDRJE Executing 2E20 0000 The specified LDEV is not defined.
CMDRJE Executing 2E21 9000 The following settings cannot be performed
because the program product of LUN Manager is
not installed.
• Command device settings
• Command security settings
CMDRJE Executing 2E30 0004 The emulation type of the specified volume is not
OPEN volume.
CMDRJE Executing 2E30 0008 The command device cannot be set because LDEV
is used as a virtual volume of Thin Image or Copy-
on-Write Snapshot.
CMDRJE Executing 2E30 000C The specified volume cannot be set because it is a
quorum disk.
CMDRJE Executing 2E30 000D The specified volume cannot be set because it is a
system disk.
CMDRJE Executing 2E30 000E The specified volume cannot be set because it is a
pool volume.
CMDRJE Executing 2E30 0012 The specified LDEV cannot be released because it
is command device that is being used.
CMDRJE Executing 2E30 0013 The specified volume cannot be set because it is a
LUSE volume.
CMDRJE Executing 2E30 0014 The command device cannot be set to the specified
LDEV because of the following causes.
• It is used as a Volume Migration.
• The reserve attribute of a Volume Migration is
configured.
CMDRJE Executing 2E30 0019 The specified volume cannot be used as a
command device because it is set by a Data
Retention Utility.
Troubleshooting
9-57
Command Control Interface User and Reference Guide
To Next Page
Loading...
