raidcom modify ldev -quorum_disable
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E10 A007 The setting of the quorum disk was released but
the operation failed.
If you display the ldev information using raidcom
get ldev command, "QRD" (that means the disk is
the quorum disk) is not displayed on VOL_ATTR
because the quorum disk setting was released. But
the management information possibly remains in
the external volume.
If you define again an external volume in which the
management information remains as a quorum
disk, an error may occur. When you reuse an
external volume which was used as a quorum disk
after removing it, format the external volume.
CMDRJE Executing 2E11 0053 The specified LDEV is being used for other
operation.
CMDRJE Executing 2E20 0000 LDEV is not installed.
Get Command
Status
Async 2E21 810A A shared memory is not installed.
CMDRJE
Get Command
Status
Executing 2EE8 FEEC Internal error occurred.
Table 9-39 SSB codes returned by raidcom delete lun
raidcom delete lun
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B958 0107 An internal error occurred.
CMDRJE Executing B958 0155 The other than multiplatform volume or OPEN
volume is included in the specified LDEV.
CMDRJE Executing B958 015D An used LDEV exists in the specified LDEV.
CMDRJE Executing B958 0202 It cannot be deleted because it is the last path of a
TrueCopy or GAD pair.
CMDRJE Executing B958 0203 It cannot be deleted because it is the last path of
ShadowImage.
CMDRJE Executing B958 020A It cannot be deleted because it is the last path of
Thin Image or Copy-on-Write Snapshot.
CMDRJE Executing B958 020B It cannot be deleted because it is the last path of
Universal Replicator.
CMDRJE Executing B958 020F The specified LDEV is not installed.
Troubleshooting
9-67
Command Control Interface User and Reference Guide
To Next Page
Loading...
