raidcom discover lun
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E10 8404 The iSCSI virtual port mode for the specified port
is disabled.
CMDRJE Executing 2E20 8401 The specified virtual port is not defined.
Table 9-43 SSB codes returned by raidcom modify pool
raidcom modify pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 0000 The LDEV number is out of the valid range.
CMDRJE Executing 2E00 0003 The SSID is out of the valid range.
Get Command
Status
Async 2E00 0010 The specified LDEV number is already used.
Get Command
Status
Async 2E00 0013 There are not enough cache management devices.
Get Command
Status
Async 2E00 0016 The command cannot be executed by receiving
multiple operations for the same pool ID.
CMDRJE Executing 2E00 002F The specified attribute is invalid.
CMDRJE Executing 2E00 6000 The value of pool ID is invalid.
CMDRJE Executing 2E00 6001 The specified pool is for Thin Image or Copy-on-
Write Snapshot.
CMDRJE Executing 2E00 6002 The specified maximum reserve rate is not in the
effective range.
CMDRJE Executing 2E00 6003 The specified Tier Range value is invalid.
CMDRJE Executing 2E00 6004 Relations between the specified lower limit of Tier
Range and the Delta value is invalid.
CMDRJE Executing 2E00 6006 The specified Tier capacity threshold value is out of
range.
CMDRJE Executing 2E00 6009 The threshold of the specified High water mark is
out of range.
CMDRJE Executing 2E00 600A The operation cannot be performed because the
specified threshold of Warning is larger than the
threshold of the specified High water mark.
CMDRJE Executing 2E00 6100 The specified tier number is out of range.
CMDRJE Executing 2E02 0202 The threshold value cannot be changed to the
specified value, because the specified pool is used
for Data Direct Mapping.
Troubleshooting
9-73
Command Control Interface User and Reference Guide
To Next Page
Loading...
