Hitachi HUS VM - Page 398

raidcom modify pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE
Get Command
Status
Executing/
Async
2E10 001F The operation cannot be performed because the
total capacity of virtual volumes for Dynamic
Tiering or active flash in the system exceeds the
maximum.
CMDRJE Executing 2E10 600B The specified pool is in the state of blocked.
Get Command
Status
Async 2E10 600C The setting of the threshold value is less than the
pool usage value.
CMDRJE Executing 2E10 600D The operation cannot be performed because it is in
the state of shrinking.
CMDRJE Executing 2E10 6011 The operation cannot be performed because it is
being discarded pages.
Get Command
Status
Async 2E10 6012 Pool cannot be restored because the usage rate of
pool is 100%.
Get Command
Status
Async 2E10 6014 The operation cannot be performed because the
specified pool status is incorrect.
CMDRJE Executing 2E10 6015 The operation cannot be performed because the
Tier is being deterred reallocation.
CMDRJE Executing 2E10 6017 The operation cannot be performed because
collecting the performance monitoring data is being
prepared.
CMDRJE Executing 2E10 601D The specified pool cannot be changed to the pool
for Data Direct Mapping, because the threshold
value of High water mark is fixed.
CMDRJE
Get Command
Status
Executing/
Async
2E10 601F The deduplication function is set to be enabled for
the specified pool.
Get Command
Status
Async 2E10 6020 The deduplication function cannot be used in the
specified pool.
CMDRJE
Get Command
Status
Executing/
Async
2E10 8000 The operation cannot be performed because
Storage Navigator or Device Manager - Storage
Navigator is in progress, another application is in
progress on the SVP, or the configuration is being
changed. Wait a while, and then retry the
operation.
CMDRJE
Get Command
Status
Executing/
Async
2E11 0205 The operation cannot be performed because the
total capacity of provisioning virtual volumes and
deduplication system data volumes defined in the
specified pool exceeds the maximum of reserved
pool capacity.
CMDRJE Executing 2E11 6003 The pool is not in the status where the pool option
can be set.
Get Command
Status
Async 2E11 8004 The operation cannot be performed because of the
internal processing.
9-74
Troubleshooting
Command Control Interface User and Reference Guide