raidcom add snapshot
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E30 007A The command ends abnormally because the
volume other than OPEN-V is specified as the P-
VOL of a Thin Image pair or a Copy-on-Write
Snapshot pair.
CMDRJE Executing 2E30 007B A pair cannot be created because the volume
whose command device is set is specified as the P-
VOL of a Thin Image pair or a Copy-on-Write
Snapshot pair.
CMDRJE Executing 2E30 007C The command ends abnormally because the
volume other than OPEN-V is specified as the S-
VOL of a Thin Image pair or a Copy-on-Write
Snapshot pair.
CMDRJE Executing 2E30 007D A pair cannot be created because the volume
whose command device is set is specified as the S-
VOL of a Thin Image pair or a Copy-on-Write
Snapshot pair.
CMDRJE Executing 2E30 007E The command ends abnormally because the
volume having no path definition is specified as the
P-VOL of a Thin Image pair or the specified Thin
Image pair does not exist.
CMDRJE Executing 2E30 007F The command ends abnormally because the
volume having no path definition is specified as the
S-VOL of a Thin Image pair or the specified Thin
Image pair does not exist.
CMDRJE Executing 2E30 0080 The command ends abnormally because the
external volume mapped for the online data
migration is specified as the P-VOL of a Thin Image
pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E30 0081 The command ends abnormally because the
external volume mapped for the online data
migration is specified as the S-VOL of a Thin Image
pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E30 0090 The pair operation is rejected because the specified
volume as the primary volume is a reserved
volume for GAD, or a volume for the GAD pair
which is in the invalid status.
CMDRJE Executing 2E30 0091 The pair operation is rejected because the specified
volume as the secondary volume is a reserved
volume for GAD, or a volume for a GAD pair.
CMDRJE Executing 2E30 0099 The specified LDEV is a volume of which Data
Direct Mapping attribute is enabled.
CMDRJE Executing 2E30 0201 The specified LDEV is an external volume of which
Data Direct Mapping attribute is enabled.
CMDRJE Executing 2E30 0202 The specified LDEV is a virtual volume of which
Data Direct Mapping attribute is enabled.
9-92
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
