Hitachi HUS VM - Page 446

raidcom delete rcu
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE
Get Command
Status
Executing/
Async
2E00 8400 The value of the specified port is invalid.
Get Command
Status
Async 2E11 8004 The operation cannot be performed because the
microcode is being changed.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2E20 3000 The serial number, the product ID, or the SSID of
the target storage system is incorrect.
Get Command
Status
Async 2E20 3001 The specified RCU cannot be deleted because the
RCU is not registered.
Get Command
Status
Async 2E21 7101 The specified CU number is not defined, or an
LDEV is not defined under the CU number.
Get Command
Status
Async 2E22 3101 The path cannot be deleted because there is a pair
of TrueCopy/Universal Replicator, or a journal
volume is in the target CU.
Get Command
Status
Async 2E31 3001 The command cannot be executed because the
RCU identification code of a path is invalid.
CMDRJE Executing 2ED6 00EE The command cannot be accepted because the
DKC is busy. After a while, execute the same
command.
Get Command
Status
Async 2ED6 3005 An internal error occurred.
Call Hitachi Data Systems customer support.
CMDRJE Executing 2ED6 3300 The value of SSID on the remote storage system is
invalid.
CMDRJE Executing 2EDE 00D1 RCU storage system does not exist.
CMDRJE Executing 2EF3 3002 The specified parameter is invalid. Check the
Command Control Interface Command Reference.
Table 9-61 SSB codes returned by raidcom add rcu
raidcom add rcu
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 3001 The value of CU# on the RCU exceeds the effective
range.
CMDRJE Executing 2E00 3005 Invalid product ID or path registration ID.
Get Command
Status
Async 2E00 3008 The command cannot be executed because the
parameter of the specified RCU is invalid.
9-122
Troubleshooting
Command Control Interface User and Reference Guide