raidcom modify port -port_attribute
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Call Hitachi Data Systems customer support.
CMDRJE Executing B980 B901 The command was rejected because the specified
port is for NAS Platform (System LU).
CMDRJE Executing B980 B902 The command was rejected because the specified
port is for NAS Platform (User LU).
Table 9-71 SSB codes returned by raidcom modify port -delayed_ack_mode
raidcom modify port -delayed_ack_mode
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 1039 The command device being used at the local CCI
exists under the port.
CMDRJE Executing B955 120E The command cannot be executed because the
iSCSI virtual port mode is ON.
Table 9-72 SSB codes returned by raidcom modify port -ipv4_address
raidcom modify port -ipv4_address
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 1039 The command device being used at the local CCI
exists under the port.
CMDRJE Executing B955 10B3 The network address, loop-back address, broadcast
address or the IP address beginning with 255
cannot be used as the IP address for IPv4.
CMDRJE Executing B955 120E The command cannot be executed because the
iSCSI virtual port mode is ON.
Table 9-73 SSB codes returned by raidcom modify port -ipv4_subnetmask
raidcom modify port -ipv4_subnetmask
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 1039 The command device being used at the local CCI
exists under the port.
CMDRJE Executing B955 10DB The subnet mask cannot be set because the
specified value is invalid.
9-134
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
