Hitachi HUS VM - Page 474

raidcom modify host_grp
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B958 098E When using 8FC16 or 16FE10 channel package,
you cannot configure the host mode option 51
(Round Trip Set Up Option) for the host group
because the host mode option 51 is not supported.
CMDRJE Executing B980 B901 The command was rejected because the specified
port is for NAS Platform (System LU).
CMDRJE Executing B980 B902 The command was rejected because the specified
port is for NAS Platform (User LU).
CMDRJE Executing B980 B903 The command was rejected because the selected
resource belongs to NAS_Platform_System_RSG.
Table 9-100 SSB codes returned by raidcom disconnect path
raidcom disconnect path
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 4500 The path group is out of the enabled range.
CMDRJE Executing 2E00 8400 The value of the specified port is invalid.
CMDRJE Executing 2E02 8403 The specified virtual port number is out of range.
Get Command
Status
Async 2E10 4301 The specified external path has already
disconnected the path, or is in the process of
checking path.
CMDRJE Executing 2E10 8404 The iSCSI virtual port mode for the specified port
is disabled.
Get Command
Status
Async 2E11 001B The target LDEV is blocked.
Get Command
Status
Async 2E11 4000 The path for the specified external path is in the
state of disconnected.
Get Command
Status
Async 2E11 4302 This command cannot be operated due to one of
the following reasons:
• All the paths to the external volumes are
blocked.
• There will be no normal paths.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
CMDRJE
Executing/
Async
2E20 4100 There is no specified external volume.
Get Command
Status
Executing/
Async
2E20 4300 There is no connection path to an external volume.
9-150
Troubleshooting
Command Control Interface User and Reference Guide