Hitachi KH330E - Connections; Connecting to the Earphones Socket; Knowing When to Replace the Batteries

Connections
Connecting to the Earphones Socket
1. Connect earphones (3.5mm stereo plug) to the Earphones socket.
2. Adjust the volume control to obtain the desired volume level.
3. When the earphones are connected, the speakers will automatically mute.
Make sure that the volume level is set to 1 before you plug in the earphones
and then adjust to the desired level to prevent damaging your hearing.
Knowing when to Replace the Batteries
• When the batteries lose power, the sound becomes weak and distorted.
• When the batteries are completely exhausted, the power will turn o.
• Replace all the batteries with new ones. After the batteries have been replaced, press the
STANDBY button to switch the unit on.
Handling the Batteries
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which
could cause personal injury or damage to property.
• Install the batteries correctly by following the polarity (+ and –) indications in the battery
compartment.
• Use only the types of the batteries which are indicated in this manual.
• Do not install new batteries with used ones and do not mix dierent types of batteries.
• Do not dispose of the used batteries as domestic waste. Dispose of them in accordance
with local regulations.
• If you are not going to use the unit for a long time, remove the batteries to avoid damage
from battery leakage and corrosion.
• Due to the short battery life span of some alkaline batteries. It is recommended to use
rechargeable batteries. You will need to purchase a charger to charge the rechargeable
batteries. This saves cost and is more environmentally friendly.
12
GB
KH330E_IB_GB_110321.indd 12 3/21/11 2:54 PM