Hitachi L200 Series Service Manual

1-6
The front cover can be removed without any instruments. When you remove the front cover, you can set the mode
switch and set wire at the control-terminal, the main-terminal and the intelligent relay、output terminal.
control-terminal
intelligent relay
output terminal
main terminal
control-terminal
main terminal
intelligent relay
output terminal
u
pp
er cover
rear cover
L200-002～007LFR
front cover
to
p
cover
coolin
g
fin
housin
g
volume
digital operator
g
round
connector cover
front cover
rear cover
coolin
g
fin
housin
g
to
p
cover
volume
digital operator
g
round
L200-015～037LFR
L200-004～037HFR
connector cover
Note: The upper cover is for maintenance.
Please do not remove.

Hitachi L200 Series Specifications

General

Output Frequency	0.1-400Hz
Communication	RS-485 (Modbus RTU)
Frequency Range	0.1-400Hz
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +65°C
Input Voltage	200-240V
Control Method	V/f control, Sensorless vector control
Overload Capacity	150% for 60 seconds
Protection	Overcurrent, overvoltage, undervoltage, overload, overheating, short circuit
Output Voltage	3-phase, 0 to input voltage
Cooling Method	Forced air cooling
Humidity	5% to 95% RH (non-condensing)
Altitude	Up to 1000m without derating
Braking Unit	Built-in braking transistor (for models up to 7.5kW), External braking resistor can be connected