Hitachi PC-ARF1 - Louver Swing Direction; 5 Operation; Operation Start; Operation Stop

P5417005
5
6. OperationLock
• This function is used to lock a setting.
• The following functions are applicable.
(a) Operation Mode (MODE)
(b) Temperature Setting (TEMP)
(c) Fan Speed (SPEED)
(d) Louver Swing Direction (LOUV.)
NOTE:
When “Lock function for operation mode
selection” is selected, the operation lock
performs the following procedures
4.3 Louver Swing Direction
(1) Press “ ” (On/Off).
Make sure that the power is ON.
Press “
” or “ ” and select “LOUV.”.
NOTE:
For the indoor unit without the auto louver
mechanism, the indication of “LOUV.” will NOT
be displayed on the LCD.
(2) By pressing “ ” or “ ”, the louver direction
will be changed as follows.
NOTE:
• The air ow angle is different for each indoor
unit type. Check for detailed information in
“Louver Swing Direction” of each operation
manual for indoor unit.
• The louver position on the LCD and the actual
louver position may not match during the auto
swing operation.
To set the louver positions, set the angle after
checking the position on the LCD.
• The louver may NOT stop immediately after
the switch is pressed.
5. Operation
5.1 Operation Start
Press “ ” (On/Off).
The run indicator will be turned on and the
operation will be started.
NOTE:
< Temperature/Air Flow Setting >
Temperature set-point and air ow settings will
be retained after the indoor unit is turned off at
the controller. If a setting change is required,
refer to Sections 3.1 to 4.3.
: Auto swing operation will be started. At this
time, the louver will swing repeatedly on the
LCD.
Auto-Swing
Angle
Range
Angle
Range
LCD Indication COOL, DRY HEAT, FAN
OK
On/Off
OK
On/Off
NOTE:
The indoor unit fan may continue to operate for
up to two minutes following the heating cycle to
dissipate residual heat from the indoor unit.
5.2 Operation Stop
Press “ ” (On/Off) again.
The run indicator will be turned off and the
operation will be stopped.
OK
Menu
Back/Hel
p
OK
Menu
Back/Hel
p