Hitachi PC-ARF1 - Simple Timer Operation

8
P5417005
8.2 Simple Timer Operation
• This function is used to start or stop the unit
operation at the set time.
• The timer operation contents can be set from
“Not Used”, “Once” or “Everyday”.
(1) Select “Simple Timer” from the “Menu” and
press “OK”.
The “Simple Timer” setting will be displayed.
(2) Press “ ” or “ ” to select the setting data.
The setting data are displayed “Timer Ope.”,
“ON Time” and “OFF Time”.
NOTE:
If the present time has not been set yet, “Set
Date/Time” will automatically be displayed.
Refer Section item 8.15 “Adjusting Date/Time”.
(3) Press “ ” or “ ” to set each setting data for
the selected details.
When “Timer Ope.” is selected, the setting
contents are switched between
“Not Used” ↔ “Once” ↔ “Everyday” by
repeatedly pressing “ ” or “ ”.
When “ON Time” or “OFF Time” is selected,
the setting time can be adjusted by 30-minute
increments by pressing “ ” or “ ”.
By pressing and holding “ ” or “ ”, the
setting time can be changed continuously.
NOTE:
• If “Once” on the timer operation setting
is selected, the setting content will be
automatically changed to “Not Used” after one
timer operation.
• Do not set the same hour for both ON/OFF
timers.
Menu
Power Saving Setting
Elevating Grille
Operation Schedule
Reset Filter Sign Time
01
/
05
Simple Timer
15:10(Fri)
Entr RtrnSel.
Back
OK
OK
Menu
Back/Hel
p
Simple Timer
Execute
Not Used
ON Time
- - : - -
OFF Time
- - : - -
15:10(Fri)
Entr RtrnSel. Adj.
OK
Back
Simple Timer
Execute
Everyday
ON Time
08 : 30
OFF Time
- - : - -
15:10(Fri)
Entr RtrnSel. Adj.
Back
OK
OK
Menu
Back/Hel
p
(4) Press “OK” to nish the “Simple Timer”
setting. The conrmation screen will be
displayed.
(5) Select “Yes” by pressing “ ” or “ ” and press
“OK”. The setting will be conrmed and the
screen will return to the normal mode.
“ ” will be indicated when the
timer operation is activated.
NOTE:
If the following happens, the “Simple Timer”
operation is NOT available:
* When the operation is prohibited by the
controller and set from the central controller.
* When “ ” is indicated on the LCD, the timer
operation cannot function. Set the date and
time according to Section 8.15 “Adjusting
Date/Time”.
Set timer operation?
Simple Timer
Yes No
Sel. Entr Rtrn
15:10(Fri)
Back
OK
OK
Menu
Back/Hel
p
OK
Menu
Back/Hel
p
OK
Menu
Back/Hel
p
OK
Menu
Back/Hel
p
OK
Menu
Back/Hel
p
OK
Menu
Back/Hel
p