5. Function Menu Screen Display
A16381TMEU
35
•
FrostWash Intervals (Page 36 )
You can set the total operating time of the indoor unit as below.
Function 1 Auto-FrostWash
When the total operating time reaches the set value, FrostWash is performed while
the operation is stopped.
Function 2 Manual FrostWash
When Auto-FrostWash is disabled, the total operating time reaches the set value, the
icon is displayed on the operation screen, so use it as a guide for manual
FrostWash.
NOTES:
•
The icon
disappears when performing Manual FrostWash or you enable the Auto-FrostWash.
•
Manual FrostWash may not be performed when in continuous fan mode with the icon .
FrostWash can be performed.
•
Set Auto-FrostWash Schedule(Page 37 )
performed in the available time slot.
Auto-Frost Wash Schedule
Available Time Slot Weekday
Back
22 : 00 23 : 00~
-- : -- -- : --
~
-- : -- -- : --~
~
-- : -- -- : --~
1
2
3
4
5
Press Up and Down to adjust
Sunday
-- : -- -- : --
Mon PM05:34
Set the schedule for Auto-FrostWash as the following.
○
○
"Weekday": "Monday to Sunday" and "Everyday" can be selected.
•
FrostWash Operation History (Page 39 )
This function is used to check and delete the FrostWash record.
5.12.3 Set FrostWash
NOTE:
•
In the case of 2 remote controllers, FrostWash can be set only on the primary wired remote controller.
1.
Set FrostWash
Function Menu
Individual Louver Setting
Filter Cleaning
FrostWash Setting
Reset Filter Sign Time
Elevating Grille
OK
Select Back
(Mon) 16:30
During FrostWash, a freezing sound and fog may
occur. This is a normal occurrence.
OK
Back
Step1. Select "FrostWash Setting" in Function Menu, and press
"OK".
Step2. Press "OK".
Condition
①
from 22:00 to 23:00 on Sunday.
Condition
②
The total operation time of the indoor unit has reached the
FrostWash interval (The default time is 100 hours).
Condition
③
When the indoor unit is OFF or stopped operation.
To Next Page
Loading...
