5. Function Menu Screen Display
40
A16381TMEU
5.13 Individual Louver Setting
This function is to individually set the air direction of multiple air outlets.
NOTES:
•
This function is available when the indoor unit supports individual louvers.
•
It cannot be set while the air conditioner is stopped.
•
operation is back to normal.)
•
As for "Start-up of Heating Operation", "During Defrost Operation" and "Activation of Thermo-Controller", all
the louver angles are automatically secured horizontally when this function is activated.
•
This function is not available if two remote controllers (including a combination of wired controller + wireless
controller) are used.
5.13.1 Individual Louver Setting
1.
Individual louver setting
Step1. Select "Individual Louver Setting" on the "Function
Menu" and press "OK".
Step2. Select "Individual Louver Setting" and press "OK".
NOTE:
•
If there is one indoor unit connected with the
controller, Step4 is displayed
.
Step3. Press" ", " ", " ", or " " to select the indoor unit to
change the louver direction, and press "OK".
NOTE:
•
individual louver is set.
Step4. Press " " or " " and select the louver from 1 to 4.
The selected louver is opened while the unselected
louvers are closed.
Function Menu
Individual Louver Setting
Filter Cleaning
FrostWash Setting
Reset Filter Sign Time
Elevating Grille
OK
Select Back
(Mon) 16:30
Individual Louver Setting
Cancel Individual Louver Setting
Individual Louver Setting
OK
Select Back
Individual Louver Setting
00-00
00-01
00-02
OK
Select Back
Select Unit to Set
00-00
Adjust air direction & louver angle.
1
2 3 4
OK
Back
Indv. Indv. Indv. Indv.
To Next Page
Loading...
