Hitachi RAS-4-HNCE - Removing Bottom Service Cover and Rear Cover; Removing Upper Cover

10. Servicing
392
SMGB0079 rev.0 - 01/2013
10.4.1.3 Removing upper cover
1 Remove the upper cover upward after removing 9 xing screws.
1. Upper cover.
1
10.4.1.4 Removing bottom service cover and rear cover
1 Remove 5 screws which x the bottom service cover. Pull and remove the bottom service cover.
2 Remove the upper cover following Removing upper cover.
3 Remove 9 screws which x the rear cover. Pull backward and remove the rear cover.
Rear Cover
Valve Stay
Electrical Box
Front Side
Piping Cover
Air Outlet Grille
Air Outlet Grille
Valve Stay
Front Side
Piping Cover
Rear Cover
Electrical Box
Rear Cover
Air Inlet Grille
Position of
Ambient
Thermistor
Air Inlet Grille
Rear Cover
Position of
Ambient Thermistor
N O T E
Payattentionthatthescrewlengthfortheambientthermistordiffersfromotherxingscrews.