Hitachi RPC-6.0FSN2E - Removal of the Electrical Box

10 Servicing
327
10
SMGB0077 rev.0 - 01/2013
10.3.5 Removal of the electrical box
Nº Part
1 Electrical box set screw
2 Drainage pump connector (PCN6)
3 Automatic louver connector (CN17)
4 Outlet thermistor (THM2)
5 Automatic louver electrical box set screw (THM2)
6 Fan motor connector (CN203)
7 Fan motor connector (CN201)
Remove the air inlet grille as indicated in chapters Removal of the
air lter and Removal of the air inlet grille.
Remove the electrical box as follows:
1 Remove the electrical box cover.
2 Disconnect the thermistors (THM2), the drainage motor
connector (PCN6), the oat switch connector (CN14), the
automatic louver connector (CN17) and the fan motor
connector (PCN203, CN201) from the PCB.
3 Remove the three set screws from the electrical box and
remove carefully.