10 Servicing
347
10
SMGB0077 rev.0 - 01/2013
Nº Part
1 PCB
Carefully remove the securing supports from the printed control
board (PCB) (four) by pressing carefully on the support tabs with
long-tipped pliers.
C A U T I O N
• Do not touch the electrical components of the PCB.
• Do not apply force to the PCB, as this could damage it.
• Pay special attention to the position of the connectors
on the PCB. An incorrect position during installation may
damage the PCB.
Nº Part
1 Extended support part
2 PCB
To Next Page
Loading...
