Removing Front Panel (RPK-2.0 HP)
In order to connect the refrigerant piping, wiring and to
check drain water flow, removing the right side cover is
needed. Perform this work according to the following
instructions. Pay an attention to the resin components not
to scratch.
1. Remove three bushings as shown and remove the
screws as shown below
2. Slowly pull the lower side of the front panel at your side
by paying attention to the air outlet part without touching
the outlet grille.
3. Slightly lift the front panel upward in order to release the
combined parts (three parts) of upper side of the front
panel.
Removing Front Panel (RPK-(2.5-4.0) HP)
In order to connect the refrigerant piping, wiring and to
check drain water flow, removing the right side cover is
needed. Perform this work according to the following
instructions. Pay an attention to the resin components not
to scratch.
1. Remove three bushings as shown and remove the
screws as shown below
2. Slowly pull the lower side of the front panel at your side
by paying attention to the air outlet part without touching
the outlet grille.
3. Slightly lift the front panel upward in order to release the
combined parts (four parts) of upper side of the front
panel.
To Next Page
Loading...
