Hitachi RPK-0.8FSNH2M - Emergency Operation; Operation and Function

6
EMERGENCY OPERATION
14
6. EMERGENCY OPERATION
6.1. OPERATION AND FUNCTION
In case that the unit is required to be operated when the wireless remote control switch is out of battery and can not function,
etc., the unit can be operated by the emergency operation switch.
NOTE:
The unit will operate at the following setting.
Automatic COOL/HEAT Operation
Temperature: 25
| C
Fan Speed: High
Swing Louver: Horizontal

(0.8-1.5) HP
±
±
Step 1
Press the emergency operation switch by using a small
bar or things like that.
±
Step 2
During emergency operation, if pressing the emergency
operation switch again, the unit will be stopped.
 CAUTION:
Do not press the emergency operation switch by
using metals such as a pen or a needle.It will cause a
failure.

(2.0-4.0) HP
±
Step 1
Pull up right and left side of the air intake grille as shown
in the figure below.
±
Step 2
Press the emergency operation switch by using a small
bar or things like that. Alarm code indication identifying
each Indoor unit as shown in figure below.
±
Step 3
During emergency operation, if pressing the emergency
operation switch again, the unit will be stopped.
Timer Filter/Defrost/Run
Emergency
operation
Air filter
Emergency
operation
switch (2.0 HP)
Emergency
operation switch
(3.0~4.0 HP)