4-5
■In case of use of the external power supply
■Setting input sensitivity
Signal level is completed after the input sensitivity time is
passed from switching the signal level.
*) In case that malfunction occurs due to noise, please set
the above parameters for a long time.
■Setting allowed gap time
Allowed gap time is set for switching redundant input
simultaneously. Mainly, the time difference between
redundant inputs can be allowed when the redundant
inputs are released.
*) If the allowed gap time is short, the Safety function
cannot be released.
■Checking test pulse input
P1-FS can check the input terminals for test pulse from
output terminal S13. The path error will occur if the test
pulse is not recognized correctly.
00:Inactivated / 01:Activated
To Next Page
Loading...
