Hitachi SJ Series - Page 25

4-11
Chapter 4
Safety Function
■Troubleshooting for setting patrameters to P1-FS
(1) An error is occurred
Example of error displayed:No.3
(2) A warning is occurred
Example of warning displayed:No.5
No.
message
Workaround
1
The connection have failed. Check the communication
cable and try to download again.
Check the communication cable and try to
communicate again.
2
The connection have failed. Check the communication
cable and try to upload again.
3
The connection have failed. Check the communication
cable and change the password again.
4
The password does not match. Please check the
password and try to download again.
Confirm the password and try to communicate again
5
The password does not match. Please check the
password and try to upload again.
6
The password does not match. Confirm the password and
try changing the password again.
7
Failed to read the Safety function parameters.
Try to upload again. It may be improved by noise
countermeasure of communication cable.
8
Failed to write the Safety function parameters.
Try to download again. It may be improved by noise
countermeasure of communication cable.
9
Failed to write to the data flash.
10
Failed to change the password.
11
Failed to write to the data flash.
12
The device model does not match.
Confirm the inverter trying to access. It may be
improved by noise countermeasure of
communication cable.
13
Safety function software version does not match.
14
The disconnection have failed.
Try to upload or download again. It may be improved
by noise countermeasure of communication cable.
15
Failed to disconnect the device.
16
Failed to save the file.
Try to save the file again.
17
Failed to read the file.
The file may have been rewritten. In this case, it cannot be read.
No.
message
Workaround
1
Please enter the user name. (32 characters or less)
Perform the operation again
according to the left message.
2
Please enter the password. (8 characters or less)
3
Please enter a half-width alphanumeric character without spaces for the
password.
4
The user name or the password is incorrect. Please try again.
5
The new password and its confirmation do not match. Please try typing it
again.
6
There is an error such as out of range in the setting value. Please correct the
setting value and click download.
7
There is an error such as out of range in the setting value. Please correct the
setting value and click Save file.
8
Please execute the Safety function setting after closing the {model name}
editing screen.
9
Some of uploaded parameter value are invalid. Please check the value of
the Safety function parameters that are displayed in orange.