Configuring
Drive Parameters
In This Chapter.... page
— Choosing a Programming Device .................... 2
— Using Keypad Devices ..................................... 3
— Using the PC Software — DOP Plus ............... 6
— “D” Group: Monitoring Functions...................... 8
— “F” Group: Main Profile Parameters ................. 9
— “A” Group: Standard Functions ...................... 10
— “B” Group: Fine Tuning Functions .................. 21
— “C” Group: Intelligent Terminal Functions....... 28
— “H” Group: Sensorless Vector Functions........ 36
3
To Next Page
Loading...
