Deskstar T7K250 Hard Disk Drive Specification
122
12.3 Execute Device Diagnostic (90h)
Table 67: Execute Device Diagnostic command (90h)
The Execute Device Diagnostic command performs the internal diagnostic tests implemented by the device. The
results of the test are stored in the Error Register.
The normal Error Register bit definitions do not apply to this command. Instead, the register contains a diagnostic
code. See Table 54: “Default Register Values” on page 80 for the definition.
Command Block Output Registers Command Block Input Registers
Register 7 6 5 4 3 2 1 0 Register 7 6 5 4 3 2 1 0
Data - - - - - - - - Data - - - - - - - -
Feature - - - - - - - Error see below
Sector Count - - - - - - - - Sector Count - - - - - - - -
Sector Number - - - - - - - - Sector Number - - - - - - - -
Cylinder Low - - - - - - - - Cylinder Low - - - - - - - -
Cylinder High - - - - - - - - Cylinder High - - - - - - - -
Device/Head 1 - 1 - - - - - Device/Head - - - - - - - -
Command 1 0 0 1 0 0 0 0 Status see below
Error Register Status Register
7654321 0 7654 3 21 0
CRC UNC 0 IDN 0 ABT T0N AMN BSY RDY DF DSC DRQ COR IDX ERR
VVVVVVV V 0V0- - 0- 0
To Next Page
Loading...
