Deskstar T7K250 Hard Disk Drive Specification
212
12.43.7 Error reporting
The following table shows the values returned in the Status and Error Registers when specific error conditions are
encountered by a device.
Table 137: S.M.A.R.T. Error Codes
Error condition Status Register Error Register
A S.M.A.R.T. FUNCTION SET command was received by the
device without the required key being loaded into the
Cylinder High and Cylinder Low registers.
51h 04h
A S.M.A.R.T. FUNCTION SET command was received by the
device with a subcommand value in the Features Regis-
ter that is either invalid or not supported by this
device.
51h 04h
A S.M.A.R.T. FUNCTION SET command subcommand other
than S.M.A.R.T. ENABLE OPERATIONS was received by the
device while the device was in a "S.M.A.R.T. Disabled"
state.
51h 04h
The device is unable to read its Attribute Values or
Attribute Thresholds data structure
51h 10h or 40h
The device is unable to write to its Attribute Values
data structure.
51h 10h or 01h
To Next Page
Loading...
