Hitachi T7K250 - Deskstar - Hard Drive - Write DMA FUA Ext (3 Dh)

Deskstar T7K250 Hard Disk Drive Specification
218
12.48 Write DMA FUA Ext (3Dh)
The Write DMA FUA Ext command transfers one or more sectors of data from the host to the device, and then the
data is written to the disk media. This command provides the same function as the Write DMA Ext command
except that the transferred data shall be written to the media before the ending status for this command is reported
also when write caching is enabled.
The sectors of data are transferred through the Data Register 16 bits at a time.
The host initializes a slave-DMA channel prior to issuing the command. Data transfers are qualified by DMARQ
and are performed by the slave-DMA channel. The device issues only one interrupt per command to indicate that
data transfer has terminated and status is available.
If an unrecoverable error occurs, the write will be terminated at the failing sector.
Output parameters to the device
Sector Count Current The number of continuous sectors to be transferred low order, bits (7:0).
Sector Count Previous The number of continuous sectors to be transferred high order bits (15:8). If zero is speci-
fied in the Sector Count register, then 65,536 sectors will be transferred.
Sector Number CurrentLBA (7:0)
Sector Number PreviousLBA (31:24)
Cylinder Low Current LBA (15:8)
Cylinder Low PreviousLBA (39:32)
Cylinder High CurrentLBA (23:16)
Command Block Output Registers Command Block Input Registers
Register 7 6 5 4 3 2 1 0 Register 7 6 5 4 3 2 1 0
Data Low - - - - - - - - Data Low - - - - - - - -
Data High - - - - - - - - Data High - - - - - - - -
Feature
Current - - - - - - - -
Error see below
Previous - - - - - - - -
Sector
Count
Current V V V V V V V V
Sector
Count
HOB=0 - - - - - - - -
Previous V V V V V V V V HOB=1 - - - - - - - -
Sector
Number
Current V V V V V V V V
Sector
Number
HOB=0 V V V V V V V V
Previous V V V V V V V V HOB=1 V V V V V V V V
Cylinder
Low
Current V V V V V V V V
Cylinder
Low
HOB=0 V V V V V V V V
Previous V V V V V V V V HOB=1 V V V V V V V V
Cylinder
High
Current V V V V V V V V Cylinder
High
HOB=0 V V V V V V V V
Previous V V V V V V V V HOB=1 V V V V V V V V
Device/Head - 1 - D - - - - Device/Head - - - - - - - -
Command 0 0 1 1 1 1 0 1 Status See below ...
Error Register Status Register
7654321 0 7654 3 21 0
CRC UNC 0 IDN 0 ABT T0N AMN BSY RDY DF DSC DRQ COR IDX ERR
V00V0V0 0 0V0V - 0- V