English - 18 -
USB Information
Press OK to open the USB information menu screen. Current Total space and Free
space informations of the connected USB device will be displayed. You can also format
the connected USB device using the Format Disk
option in this menu (FAT32 format
only).
Highlight and press OK to perform USB operations.
USB Option
Set as Off to disable the USB ports on the Display. You can also set this option as 5V
to provide 5 volts power over USB. In this case it will still not be available to browse the
USB content via Media Browser feature of the Display.
Video Wall Settings
Press OK to open the Video Wall Settings menu screen. Row Count, Column Count,
Cell and Offset options are available.
OPS Settings
Press OK to open the OPS Settings menu screen.
Three sub-menu options are
available.
OPS Information: Displays read-only information about the OPS unit, if supported.
OPS Status:
Displays whether the OPS module is on or off. Allows the change of
status via soft PSON signal (0.5s)
Boot Signal: Enables or disables sending of a PSON signal. The Display checks the
status signal of the OPS at bootup in order to turn it on by sending a PSON signal if
it is off. Some OPS’s send incorrect information on their status during the bootup of
the Display, so they seem to be on even though they are off. For such non-standard
OPS’s, this option must be enabled. In this case, a PSON signal will be send for the
OPS regardless of the received status information at bootup.
Powerdown: Turns the OPS off via hard PSON signal (5s)
Note: This menu will not be available if OPS is not supported or not connected to the unit.
Scheduler Settings
Press OK to open the Scheduler Settings
menu screen. You can set up to 4 different
schedulers. Highlight the Status
column of the desired scheduler option and set as
Enabled by using the Left/Right directional buttons after pressing the OK
If the Source option is set as Last
SourceSource option is set
as USB
as explained in the section entitled ‘USB Auto Play Feature. Press the Green button
Link options
Press OK to open the Link Options menu screen. Current Start url and Settings url
links will be displayed. These items are for information only and not selectable. Open
browser initial page and NTP server
related options.
Volume Settings Press OK to see available menu options.
Reset to Default
Values
Highlight this option and press the OK
button on the remote to return the Display to
default settings.
First time installation
Highlight and press OK to perform First Time Installation and reset all settings to factory
settings. You will need to enter the correct PIN to carry out this operation.
Note: Enter the PIN you have dened during the First Time Installation process.
To Next Page
Loading...
Need help?
General