Hitachi UHD8610PC - Page 28

English - 27 -
CHANGELNG Change active language.
"integer-integer x y
x = language type (0 =




4 = Primary Subtitle



7 = Secondary Teletext
Language)




















36 = Thai)
Example: CHANGELNG 0 25
(To set system language to
Turkish)
"
"#*Active language was changed
or
#*Incorrect item parameter
entered"
SETCOUNTRY
Set country in no
channels state.
string-integer n(

"#* setCountry() set to n
or
#*Country should be set only
in the FTI mode (no channels
state)"
SETQUICKSTANDBY
SETQUICKSTANDBY

on).

= OFF)
"#*Set Quick Standby on
or
#*Set Quick Standby off
or
#*Quick Standby is not enabled"
GETQUICKSTANDBY
Returns Quick Standby
state n (on or off)
no parameter #*Quick Stanby is n
USBOPERATIONS Perform USB Operations no parameter

Bank 1 etc. Be sure or observe
debug print outs: "MFC ISP: done"
will be writen... This may take over
10 minutes.