--- 9 ---
11-1. Pictograph Illustration and Explanation
Begin operation only after
making sure that there are no
people within the turning range
of the material to be bent.
Read handling instructions before use.
Never bring your hand close to the
cutter during operation.
Avoid any work exceeding the
maximum capacities.
(Rebar diameter 13 mm (1/2") )
If the switch is turned off and then
immediately turned on again, the
motor may not start. Wait for at
least one full second before
attempting to turn the motor on
again after it has been switched off.
Do not attempt to cut two rebars
at one time.
Do not use or leave this electric
power tool in wet weather
conditions.
To Next Page
Loading...
