Hitachi Virtual Storage Platform G800 - Page 123

Attribute Description
Required /
Optional
Default
value
auth.radius.server-
name.secr
et
RADIUS secret key used for PAP or
CHAP authentication
Required None
auth.radius.server-
name.retry.times
Retry times when the connection to
the RADIUS server fails.
Must be between 0 and 3. 0 means
no retry.
1
Optional 3
auth.radius.server-
name.attr.NASIdentier
Identier for the RADIUS server to
nd SVP. Specify this value if the
attr.NAS-Identier attribute is used
in your RADIUS environment. ASCII
codes up to 253 bytes long are
accepted.
Optional
2
None
auth.radius.server-
name.attr.NAS-IPv4-
Address
IPv4 address of the SVP. Specify the
value of the NAS-IP-Address
attribute. This value is transmitted
to the RADIUS server when the
authentication is requested.
Optional
2
None
auth.radius.server-
name.attr.NAS-IPv6-
Address
IPv6 address of the SVP. Specify the
value of the NAS-IPv6-Address
attribute. This value is transmitted
to the RADIUS server when the
authentication is requested.
Optional
2
None
Notes:
1. If the specied value is not applicable, the default value will be used.
2. When NAS modules are installed, set NAS-Identifier, NAS-IP-Address, or
NAS-IPv6-Address.
Table 6 RADIUS denition (for authorization server)
Attribute Description
Required /
Optional
Default
value
auth.radius.server-
name.domain.name
A domain name that the LDAP
server manages. In this manual, the
value specied here is called
domain-name
hereafter.
Required None
Creating a RADIUS conguration le
Chapter 4: User administration
System Administrator Guide for VSP Gx00 models and VSP Fx00 models 123