Make sure the storage system is connected to your production network.
Procedure
1. Connect the Fibre Channel data ports on each storage system controller to your Fibre Channel switch.
2. Connect your Fibre Channel switch to the Fibre Channel HBA card in each host computer or server.
Connecting iSCSI ports to hosts
Each controller supports 10-gigabit Ethernet copper (RJ-45) or optical (fiber) iSCSI connectivity to your data network.
Important Before connecting the storage system to a host, review the requirements and detailed instructions in the
Open-Systems Host Attachment Guide.
Before you begin
Make sure the storage system is connected to your production network.
Procedure
1. Using the appropriate cable, connect the iSCSI data ports on each storage system controller to your Gigabit
Ethernet network switch.
2. Connect your Gigabit Ethernet network switch to the NIC or HBA card in each host computer or server.
Step 11: Register your storage system with Hitachi Vantara Support
If you do not already have an account on the Support Website, you will need to register. Otherwise, you will not be able
to download and install the Hitachi Remote Ops monitoring system.
Before you begin
• Register an account on the Support Website.
Procedure
1. Locate the product serial number (labeled MFG. NO.) on the rear of the controller. You will need this number to
register your storage system.
2. Open a web browser on your PC or mobile device.
3. Log in to the Support Website, and follow the instructions to register your storage system. If you have previously
registered Hitachi Vantara products, you can add an additional site.
https://knowledge.hitachivantara.com/Documents/Storage/VSP_E_Series/93-06-4x/VSP_E1090_Installation/01_Installing_yo…
Updated: Sun, 18 Jun 2023 03:59:58 GMT
Powered by
20
To Next Page
Loading...
