Item Description
1 Bezel slots
2 Tabs
3 Key
4. On the lower left front side of the controller, press and hold the POWER ON/OFF
button until the POWER LED changes to green (about 3 seconds), and then release
the button.
Item Description
1 Controller (front bezel attached)
2 Controller (front bezel removed)
3 READY LED on controller (front bezel removed)
4 POWER LED on controller (front bezel removed)
5 READY LED on controller (front bezel attached)
6 POWER LED on controller (front bezel attached)
5. Wait for the green READY LED on the front of the controller to go on (approximately
16-25 minutes).
Note: If the READY LED does not go on after 30 minutes, contact
customer support.
Step 5: Power on the storage system
Installing your storage system
Storage system installation (without SVP) 15
To Next Page
Loading...
