■ Default Gateway: IP address of the
default gateway to which the storage
system will be connected. The
gateway is the IP address of the
router used to communicate outside
the local subnet.
■ DNS Server 1-3: If your
conguration uses DNS to resolve IP
addresses (for example, the IP
address for the NTP server used with
the storage system), enter up to
three DNS IP addresses.
Network Connection Mode Determines whether the storage
system negotiates the speed and
duplex mode automatically with the
attached device. The default setting
(Auto-Negotiation) connects the
storage system at the highest speed
and appropriate duplex setting
supported by itself and the connected
device.
Option ■ DNS Domain Name: IP address of
the DNS server that will perform
address resolution.
■ DNS Search Order: Search domain
names. Use the Up and Down
buttons to order the domain names.
■ Maintenance Port: Do not change
these values.
■ Internal Network: Do not change
this value.
4. Click Apply, and then click Close.
The system logs you out.
5. Remove the Ethernet cable from the management console and attach the cable to
your production network. Leave the other end of the cable connected to the
management port on the rear of the controller.
Running the Initial Setup wizard
Installing your storage system
Storage system installation (without SVP) 21
To Next Page
Loading...
