Item Description
1 Management port on the rear of controller 2
2 Management console
3 Production network
7. Wait 5 minutes for the maintenance utility to fetch the new IP addresses.
8. Open a web browser, and log in to Storage Advisor Embedded again. Use the new IP
address you specied in the Initial Setup wizard and the new password you
specied for the maintenance user.
9. In the top-right corner, click the gear icon, and then select User Administration.
10. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
11. Enter the system information, and then click Apply and Next.
Running the Initial Setup wizard
Installing your storage system
Storage system installation (without SVP) 23
To Next Page
Loading...
