2. Facing the front of the rack, find an empty 2U location where you will install the controller.
3. Place the left mounting rail as shown in the following figure, and then use two flathead screws to secure the rails to
the front vertical post on the rack.
NoteThe flathead screws are M5x10 (PZ-2), where PZ-2 refers to the size and type of the Philips head.
https://knowledge.hitachivantara.com/Documents/Storage/VSP_G130_GF350_GF370_GF700_GF900/88-03-0x/Installation/0…
Updated: Wed, 20 Dec 2023 21:36:41 GMT
Powered by
4
To Next Page
Loading...
