2. Open the Hi-Track Monitor Installation Guide, and follow the installation instructions.
3. After you configure Hi-Track with the appropriate Site ID, log in to Support Connect and create a Support Connect
case to inform Hitachi Vantara that your system is installed and that Hi-Track is enabled.
Installing Hi-Track completes the self-installation of your storage system.
Parent Topic
• Installing your VSP G/F350 and VSP G/F370 storage system
Where to go from here
After concluding the self-installation successfully, perform the following post-installation activities.
Parent Topic
• Installing your VSP G/F350 and VSP G/F370 storage system
Child Topics
• Configure storage system for the first time
• Configure storage system for the first time
• Read the release notes
Your storage system undergoes constant development and improvement.
• Read the latest technical bulletins
Technical bulletins are provided to communicate technical information about your storage system and to assist
you with additional information about the proper use, handling, and solving of technical issues.
• Support
The following resources provide additional information about the storage system:
Configure storage system for the first time
After you complete the self-installation of your storage system, configure the storage system to suit your requirements
using the management software (Storage Advisor, Device Manager - Storage Navigator, Command Control Interface, or
Hitachi Command Suite).
Typical configuration activities include the following:
• Set up spare drives
• Create pools and volumes
• Configure Fibre Channel and iSCSI ports
• Create a message that appears at login
• Create user accounts, and then back up the accounts
https://knowledge.hitachivantara.com/Documents/Storage/VSP_G130_GF350_GF370_GF700_GF900/88-03-0x/Installation/0…
Updated: Wed, 20 Dec 2023 21:36:41 GMT
Powered by
26
To Next Page
Loading...
