Item Description
6 POWER LED on controller (front bezel attached)
6. Wait for the green READY LED on the front of the controller to go on (approximately 16-25 minutes).
NoteIf the READY LED does not go on after 30 minutes, contact customer support.
Parent Topic
• Installing your VSP G/F350 and VSP G/F370 storage system
Step 6: Perform the initial setup
Initial setup of the storage system is performed using the Windows-based management console.
Before you begin
Confirm that the Windows-based management console has an Internet connection and an installed version of one of the
following web browsers: Internet Explorer version 11 or later, Chrome, or Firefox.
Procedure
1. Connect the management port on controller 1 and controller 2 to a management (non-production) network.
2. Configure the management console to use an IP address of 192.168.0.18 and a subnet mask of 255.255.255.0.
Next steps
Change the storage system's default password.
Parent Topic
• Installing your VSP G/F350 and VSP G/F370 storage system
Child Topics
• Changing the default password
• Running the initial setup wizard
The Initial Setup wizard allows you to configure system information, date and time settings, and network
settings.
• Configure syslog and SNMP notifications
Changing the default password
To prevent unauthorized access to your storage system, change the default password.
https://knowledge.hitachivantara.com/Documents/Storage/VSP_G130_GF350_GF370_GF700_GF900/88-03-0x/Installation/0…
Updated: Wed, 20 Dec 2023 21:36:41 GMT
Powered by
13
To Next Page
Loading...
