Hitachi VSP G1000

• Complete the following steps to confirm generated SSIDs:
a. Click View SSIDs.
b. In the View SSIDs window, confirm the SSID, and then click
Close.
• CLPR
Select CLPR.
Required: No
• MP Blade (VSP G1000, G1500, and VSP F1500)
Select the MP blade identifier to which you want to assign the LDEV. To
specify an MP blade identifier, select the MP blade ID. To assign an
arbitrary MP blade identifier, click Auto.
Required: No
• MP Unit ID (VSP Gx00 models and VSP Fx00 models)
Select the MP Unit ID to which you want to assign the LDEV. To specify
an MP Unit ID, select the MP Unit ID. To assign an arbitrary MP Unit
ID, click Auto. The MP Unit ID that you can select depends on the VSP
storage system model.
Required: No
The created LDEVs are added to the Selected LDEVs table.
Note: The Provisioning Type, System Type, Emulation Type,
LDEV Capacity, and Number of LDEVs fields must be set. If
these items are not set, you cannot click Add.
5.
Click Finish, and then confirm the settings.
Note: To continue setting the LU path, click Next.
For more information about setting the LU path, see the
Provisioning Guide for your storage system.
Configuring Thin Image 115
Hitachi Thin Image User Guide for Hitachi Virtual Storage Platform G Series and F Series