Table 9-19 SSB codes returned by raidcom add ldev
raidcom add ldev
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 0000 The LDEV number is out of settable range.
CMDRJE
Get Command
Status
Executing/
Async
2E00 0002 The specified capacity is not in the effective range.
CMDRJE Executing 2E00 0003 SSID is not in the effective range.
CMDRJE Executing 2E00 000D The value of the specified emulation type is invalid.
CMDRJE
Get Command
Status
Executing/
Async
2E00 000E The specified emulation type is not supported in
this command.
Get Command
Status
Async 2E00 0010 The operation cannot be performed because the
specified LDEV number is already used.
Get Command
Status
Async 2E00 0013 The operation cannot be performed because there
are not enough cache management devices.
Get Command
Status
Async 2E00 0014 Cannot create because the specified capacity is
invalid.
CMDRJE Executing 2E00 0019 The capacity in the case of specifying a emulation
type of the mainframe series must be dividable by
the cylinder.
CMDRJE Executing 2E00 001A The capacity when 3390-V emulation type is
specified must be divisible by page unit.
CMDRJE Executing 2E00 001C When you specify emulation type for open system,
you cannot specify the size by the cylinder.
CMDRJE
Get Command
Status
Executing/
Async
2E00 0025 The following external volume cannot be created
because the capacity which is specified with LBA is
not same as the size of the external volume group.
• An external volume for the online data
migration.
• An external volume having the Data Direct
Mapping attribute.
CMDRJE Executing 2E00 0026 The capacity must be specified because LDEVs are
in the parity group (or the external volume group).
CMDRJE Executing 2E00 0027 The capacity must be specified.
Get Command
Status
Async 2E00 002D The emulation type of the mainframe cannot be
specified because the virtual volume is set for the
specified LDEV.
CMDRJE Executing 2E00 002F The specified value of the Full Allocation is invalid.
Get Command
Status
Async 2E00 0030 Full Allocation cannot be specified to the specified
LDEV because the emulation type is not supported.
Troubleshooting
9-39
Command Control Interface User and Reference Guide
To Next Page
Loading...
