Hitachi WJ200-001S - Page 21

19
NOTE: Pressing the [ESC] key will make the display go to the top of next function group,
regardless the display contents. (e.g.   [ESC]  )


Press the both up and down key at the same
time in func. code or data display, then
single-digit edit mode will be enabled.
Refer to 2-34 for further information.
  


ESC
SET
Group "d"
Func. code display
.
  
  
  


Group "F"
Func. code display
  
  
.
.
SET
SET
ESC
SET
ESC
Save
  


Group "A"
Func. code display
  
  

 
SET
SET
ESC
SET
ESC
Data display
When data is changed, the display
starts blinking, which means that
new data has not been activated yet.
: Saves the data in EEPROM and
returns to func. code display.
: Cancels the data change and
returns to func. code display.
SET
ESC
Group "b"
  
ESC
Func. code display
: Jumps to the next group
ESC
Func. code display
: Moves to data display
SET
ESC
ESC
Data display (F001 to F003)
Data does not blink because of real time synchronizing
: Saves the data in EEPROM
and returns to func. code display.
: Returns to func. code display without saving data.
SET
ESC