Need help?Do you have a question about the Hitachi WJ200 and is the answer not in the manual?
General| Model | WJ200 |
|---|---|
| Cooling Method | Fan cooled |
| Output Frequency | 0-400 Hz |
| Control Method | Sensorless Vector Control (SVC) |
| Overload Capacity | 150% for 60 seconds |
| Protection | Overcurrent, Overvoltage, Undervoltage, Overheat, Ground Fault, Short Circuit |
| Communication | RS-485 (Modbus RTU) |
| Braking Unit | Built-in braking transistor (for some models) |
| Ambient Temperature | -10 to +50°C (14 to 122°F) |
| Enclosure | IP20 |
| Output Current | Varies by model |
| Frequency Range | 0.1-400Hz |
| Power Rating | Varies by model |
| Storage Temperature | -20 to +60°C (-4 to 140°F) |
| Humidity | Less than 95% RH (non-condensing) |
| Altitude | Up to 1000m |
| Input Voltage | 200-240V AC, 380-480V AC |
Step-by-step guide to configure the auto-speed activation level based on load.
Configures automatic reduction of carrier frequency based on output current.
Troubleshooting and adjustment guide for automatic torque boost symptoms.
Steps to configure torque limits for reducing load swing in traverse applications.
Using alternate acceleration and deceleration for smoother traverse motion.
To Next Page
