Hitachi WJ200-001S - Page 38

36
Two Stage Acceleration and Deceleration
When terminal [2CH] is turned ON, the inverter
changes the rate of acceleration and
deceleration from the initial settings ( and
) to use the second set of acceleration/
deceleration values. When the terminal is
turned OFF, the inverter is returned to the
original acceleration and deceleration time
( acceleration time 1, and 
deceleration time 1). Use  (acceleration
time 2) and  (deceleration time 2) to set
the second stage acceleration and deceleration
times.
In the graph shown above, the [2CH] becomes active during the initial acceleration. This
causes the inverter to switch from using acceleration 1 () to acceleration 2 ().
Option
Code
Terminal
Symbol
Function Name
State
Description

2CH
Two-stage Accelera-
tion and
Deceleration
ON
Frequency output uses 2nd-stage acceleration and
deceleration values
OFF
Frequency output uses the initial acceleration 1 and
deceleration 1 values
Valid for inputs:
~
Example (default input configuration shown see
page 69):
See I/O specs on page 24, 25.
Required settings
, , =
Notes:
 Function  selects the method for second
stage acceleration. It must be set =  to select
the input terminal method in order for the [2CH]
terminal assignment to operate.
[2CH]
1
0
Output
frequency
t
[FW,RV]
1
0
Target
frequency
initial
second
2CH
7
6
5
4
3
2
1
L
P24
PLC