2
Flying models can be dangerous if proper safety precautions are not followed. Here are a few critical safety
suggestions to keep you and others safe.
Are you experienced?
Flying models is not an intuitive process. Most accomplished model pilots were taught by another modeler. We encourage
you to seek help during your early ight experiences and if required, during the building and gear installation process. Unlike
some other hobbies, model airplane ying has evolved into a social event. There are approximately 2,500 model aircraft clubs
in America. Friendship and help could be right around the corner. Ask your local hobby shop about clubs in your area.
Where to Fly
Having enough land for your own model airport is rare. Most of us y at club administrated model elds. The local ball eld
can be tempting but rarely has the space needed and your liability is high should you damage property or hurt an innocent
person. We recommend you y at a sanctioned model aircraft eld.
Join the AMA
In America, the Academy of Model Aeronautics (AMA) is an organization of model enthusiasts that provide resources and
insurance to modelers. The AMA also lobbies the Government concerning legislation that impact modelers.
Visit their web site for more information, www.modelaircraft.org.
Academy of Model Aeronautics
5151 East Memorial Drive
Muncie, Indiana 47302
Toll Free : 800 435-9262
Fundamental Guidelines for Safe Flying
1. Don’t y over people or personal property.
2. Make sure you do a range and pre-ight check on your aircraft.
3. Check for others ying on your frequency. (No need with 2.4GHz)
4. Know your batteries condition. Keep them charged.
5. The equipment we use in the R/C hobby is sensitive electronic gear. Have receivers checked after a crash before using
them in another aircraft.
6. Use the Fail-Safe function in AFHSS mode to lower the throttle in case of a signal “lock-out”.
7. Don’t y alone.
Many of you have owned or used earlier model Hitec transmitters. Here are four “new” Hitec transmitter features that set the
Eclipse 7 Pro apart from all other Hitec products.
1. Signal Protocol
Using Hitecs AFHSS 2.4GHz module to link with Hitec Optima AFHSS 2.4GHz receivers.
2. Gimbals
Feel the silky smooth action of the new four ball bearing supported gimbals in the Eclipse 7 Pro. These new gimbals were cre-
ated to give you the smoothest action demanded by the highest performance aircraft.
3. Switch Assignments
During the model programming steps you will be asked to select what stick, switch or slider controls the features you want to
use with your model. This gives you unlimited exibility to choose the most comfortable and practical way for you to use the
Eclipse 7 Pro..
4. Channel and Control Assignments
The Eclipse 7 Pro will automatically select the channel and control assignments based on the model you have. There is the
option to change them if you wish, allowing you a wider choice of receivers that can be used with the Eclipse 7 Pro..
What’s New?
Safety Information
To Next Page
Loading...
Need help?
General
