HITEC X4 AC Pro - Battery Connections

14
Battery Connections
TO AVOID SHORT CIRCUITS, ALWAYS CONNECT THE CHARGE LEADS
TO THE CHARGER FIRST, AND THEN TO THE BATTERY. REVERSE THE
SEQUENCE WHEN DISCONNECTING THE PACK.
Warning
Lithium Battery Connection With
Balance Adaptor
Battery Connection for
NiMH/NiCD and PB Batteries
2S 3S 4S 5S
6S
1
2
3
4
5
6
BATTERY
DC 11-18V
BALANCE
SOCKET
BALANCE ADAPTOR
X1 CHARGER
BALANCE
LEAD
Balance Socket
For safety reasons, the default setting for charging Lithium (LiPo, Lilon, LiFe
and LiHV)batteries is using a balancing connector to connect the battery
and charger in Charge, Fast Charge, Balance Charge and Storage modes. If
your battery does not have a balance adaptor without a balance wire con-
nector, you must disable this function in the system settings as follows.
The balance wire attached to the battery must be connected to the charger
with the black wire aligned with the negative marking. Ensure correct polarity!
NiMH
ON
BAL. Connection
SYTEM SETTINGS
BATT / PROGRAM