HITEC X4 AC Pro - Page 16

16
Battery Type Process Description
LiPo
Lilon
LiFe
LiHV
CHARGE
The charge mode is for charging LiPo/LiFe/LiIon/
LiHV batteries in normal mode.
DISCHARGE
This mode is for discharging
LiPo/LiFe/LiIon/LiHV batteries.
STORAGE
This program is for charging or discharging a
lithium battery which will not be used again for
an extended period of time.
FAST CHG
A fast charge will result in a smaller than usual
charging capacity but will reduce the total
charge time.
BAL CHARGE
This mode is for balancing the voltage of Lithium
battery cells while charging.
NiMH
NiCd
CHARGE
The charger will charge NiMH and NiCd batteries
using the charge current set by the user.
AUTO CHG
In this program, the charger detects the condi-
tion of the connected battery and automatically
charges the battery.
Note: You should set the upper limit of the charge
current to avoid damage by excessive charging current.
The X4 AC Pro may not be able to detect the charge
capacity of low resistance batteries.
DISCHARGE
This mode is for discharging a NiMH/NiCd battery
RE-PEAK
In re-peak charge mode, the charger can peak
charge the battery once, twice, or three times
in a row automatically. This is good for
conrming the battery is fully charged and for
checking how well the battery receives
fast charges.
CYCLE
Automatically charges/discharges the battery up
to 5 times. This process can enhance the perfor-
mance of NiMH/NiCd batteries.
Pb
(Lead Acid)
CHARGE
This mode is for charging a Pb battery.
DISCHARGE
This mode is for discharging a Pb battery.