HITEC X4 AC Pro - Lithium Battery Discharge Mode

20
66
3.81 3.82 3.81
0.00 0.00 0.00
Fuel = 66%
Cell = 3.98V
66
Lithium Battery Program (continued)
Program Stop
During the charging process, press STOP button to stop the process.
Program Complete
When the charging process is nished, an audible
sound will be heard and the charger will indicate
END: FINSHED. The charger displays the total pack
voltage, total mAh fed into the battery and the
elapsed time of the process.
NOTE: The battery charge indicator displays Green during charging and Red
during discharging.
[ END: FINISH ]
12.60V 02001mAh
TIME: 00:32:15
12.60V 02001mAh
100
100
This screen shows the voltage of each individual cell
when a balancing cable is connected.
Charged capacity percentage and average cell voltage
of the pack.
Lithium Battery (LiPo, LiHV, LiFe, LiIon) Discharge Mode
The following steps will guide you through setting up a Lithium Chemistry Bat-
tery Discharge Mode.
DISCHARGING LITHIUM CHEMISTRY BATTERIES CAN CAUSE PERMANENT
DAMAGE TO THE BATTERY AND IT IS NOT RECOMMENDED FOR
ANYTHING OTHER THAN THE DISPOSAL OF THE BATTERY. IF YOU CHOOSE
TO DISCHARGE YOUR LITHIUM BATTERIES, MAKE SURE TO PAY CLOSE
ATTENTION TO THE MINIMUM VOLTAGE SETTING. IF YOU WANT TO STORE
YOUR BATTERY FOR A LONG PERIOD OF TIME YOU SHOULD UTILIZE THE
STORAGE MODE CHARGE PROGRAM AS THIS IS THE SAFEST METHOD OF
STORING YOUR LITHIUM CHEMISTRY BATTERIES.
BATT/PROGRAM Select
Press INC and DEC to cycle through all battery types
and press START/ENTER to select the appropriate
battery types to be charged.
Discharge Current
Press INC and DEC to adjust the discharge current.
Press the START/ENTER button to conrm the setting
of your choice. Adjustment range is 0.1 ~ 2.0 Amps.
Warning
2.0A 11.1V (3S)
LiPo DISCHARGE
2.0A 11.1V (3S)
LiPo DISCHARGE